Radial Arm Saw

 I went out to the garden and saw four deer.  Instead of going west over the fence, they ran to the east then turned north going east of the house.  When the got to the road they were nearly across main street.   

I began building a base or a device to hold the radial arm saw.  I had a two foot wide piece of 3/4 inch of old plywood.  I made the base to small.  I made another one that was two foot square.  I made four legs.  I tried to miter each on at 2 1/2 degrees.  That didn't work.  I ended up attaching a leg at each corner.  

I picked a half bucket of tomatoes.  

I got so busy building that I took no pictures.